Edelbrock Performer RPM Intake Manifold For Chevrolet 262-400 Small-Block V8
Edelbrock Performer RPM Intake Manifold For Chevrolet 262-400 Small-Block V8
Edelbrock Performer RPM Intake Manifold For Chevrolet 262-400 Small-Block V8
Edelbrock Performer RPM Intake Manifold For Chevrolet 262-400 Small-Block V8
Edelbrock Performer RPM Intake Manifold For Chevrolet 262-400 Small-Block V8
Edelbrock Performer RPM Intake Manifold For Chevrolet 262-400 Small-Block V8

Edelbrock Performer RPM Intake Manifold For Chevrolet 262-400 Small-Block V8

Regular price
$425.00
Sale price
$425.00
Regular price
Sold out
Unit price
per 
Tax included. Shipping calculated at checkout.

Edelbrock Performer RPM intake manifold is designed for 1955-86 262-400 c.i.d. Chevy V8's for maximum power and a broad torque curve for high-performance street/marine engines. Provides power like a single-plane and throttle response like a dual-plane. Has provisions to machine for an oil fill tube. No provisions for exhaust heated or stock-style choke. Accepts late-model water neck, air-conditioning, alternator and H.E.I. Will fit cast iron Chevrolet Bowtie heads, but will not fit 1987 and later cast iron heads. Intake manifolds will not fit under stock Corvette hood.

part #7101

SPECS

Application Application Specific
UPC 00085347071012
Series Performer RPM
Grade Type Performance
Gasket Or Seal Included No
Vehicle Model Chevrolet
Ec Basic Operating Rpm Range 1500-6500 RPM
Installation Notes
  • Manifold ht: A-4.20", B-5.25" (.70" taller than #2101); Carb pad height: 4.27"; Carb recommendations: Edelbrock AVS2 or Performer Series 650-800 cfm. Use bracket #8031 or #8036 for 1972-78. Port exit dimensions: 1.16" x 1.92"; Recommended intake gasket: Edelbrock #7201. Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant #1076, DO NOT USE END SEALS GASKETS. Use #8504 Edelbrock bolt kit. Sealant must be used on intake bolt threads if the threads extend into lifter valley or coolant passage. NPT/Pipe thread fittings require the use of Teflon tape or paste on threads to ensure proper seal. DO NOT OVERTIGHTEN NPT/Pipe fittings, this may cause the aluminium to crack around the fitting boss. NPT/Pipe thread is a tapered thread. Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminium. Will not fit under stock Corvette hood. Proper installation is the responsibility of the installer. Improper installation will void your warranty and may result in poor performance and engine or vehicle damage.
Centre Maximum Height 4.720 in
CNC Ported No
Finish Satin
Front Maximum Height 4.200 in
Material Aluminium
Rear Maximum Height 5.250 in
Single Or Dual Plane Type Dual